1. 2aHawaii
  2. Tools and Uses
  3. Firearms and Accessories
  4. Chipping at cam pin hole
Print
Pages: [1]

Chipping at cam pin hole (Read 136 times)

West740

Chipping at cam pin hole
« on: April 28, 2024, 09:58:47 PM »
Just went to sight in a new build today. Put roughly 50-60 rounds through the gun and took apart to give a quick wipe down at home. Noticed a chip on the bolt at the cam pin hole. Bcg is a Noveske. Anyone ever had this issue with such a low round count?
Logged

Flapp_Jackson

Re: Chipping at cam pin hole
« Reply #1 on: April 28, 2024, 10:03:35 PM »
Did you lube the bolt well?  That's the most important part to make sure is properly lubricated.

You can under-lube it, but too much oil won't hurt it.  You'll just risk getting oil thrown back in your face.
Logged
"How can you diagnose someone with an obsessive-compulsive disorder
and then act as though I had some choice about barging in?"
-- Melvin Udall

West740

Re: Chipping at cam pin hole
« Reply #2 on: April 28, 2024, 10:11:40 PM »
Yea I used fcd snake oil gun lube on it prior to the range. Just cleaned it off for the pic.
Logged
Print
Pages: [1]
« previous next »