2aHawaii

Tools and Uses => Reloading => Topic started by: Bcspy on October 31, 2013, 12:53:31 PM

Title: Reloading 338 Lapua
Post by: Bcspy on October 31, 2013, 12:53:31 PM
Just recently purchased a Lyman 338 Lapua dies set.  I use Dillon lube and work great for 308 and 223.  Never again for 338 Lapua Brass.  The brass got stuck, unable to take it out, and now the size die is trashed.  Any better lube and I need to buy new dies and mix review with Foster and Redding.  Not sure what to buy.  I see comp and S type for Redding.  Price is high so I don't want to make any mistake on purchasing.  I should have buy and cry once.   
Title: Re: Reloading 338 Lapua
Post by: powder monkey on October 31, 2013, 02:08:06 PM
imperial sizing wax and co ax press........ :thumbsup:
Title: Re: Reloading 338 Lapua
Post by: Bcspy on December 06, 2013, 05:03:52 PM
Anyone got the Sierra reloading data book?  Just want to double check my load.  I'm about to load 338 Lapua Sierra MK 250 HPBT, Hornady brass, 85 gr of H4831, trim 2.714, and oal 3.550.  Need to double check the grain min and max load.  Thanks
Title: Re: Reloading 338 Lapua
Post by: ren on December 06, 2013, 05:08:22 PM
Did you try placing the stuck case and die in the freezer; then try to remove it?
Title: Re: Reloading 338 Lapua
Post by: Bcspy on December 06, 2013, 05:35:28 PM
No the die decap pin is trashed.  Body still good.  I pick up the redding die set and .364 and .365 bushing.   Using .365 and also the wax is awesome.  Thanks for the tip. Never got any stuck after use.