2aHawaii

General Topics => General Discussion => Topic started by: TastesLikeMetal on November 22, 2013, 08:58:42 PM

Title: Duracoat Shake 'N Spray Finishing Kit
Post by: TastesLikeMetal on November 22, 2013, 08:58:42 PM
Anyone sell this locally?  I want to recoat my 10/22's Barrel/Receiver Black.  If not I'll probably Rattle-can it.

Thanks
Ray
Title: Re: Duracoat Shake 'N Spray Finishing Kit
Post by: Boomah on November 22, 2013, 09:39:14 PM
I haven't run across any locally, Aluma Hyde II is all I've been able to find... Security Equipment is normally where I find it.  It's rattle-can, air dry, and cure.   Comes in a few colors, SE carries flat black (which ends up semi-gloss after a little handling with oily gloves/hands), dark gray, tan, OD, and brown.   I've had a good luck with AH II but it's quite thick, even after it's cured (that takes about a week or two).   So you have to be careful if applying to parts with tight tolerances ;)

HTH, Ahui hou  :shaka:

Boomah

 
Title: Re: Duracoat Shake 'N Spray Finishing Kit
Post by: TastesLikeMetal on November 22, 2013, 09:48:59 PM
Thanks, I'll probably end up at the Depot tomorrow to pick up some Krylon Black.
Title: Re: Duracoat Shake 'N Spray Finishing Kit
Post by: TastesLikeMetal on November 22, 2013, 09:50:04 PM
Anyone have input on what Spray Paint is okay for the Barrel?
Title: Re: Duracoat Shake 'N Spray Finishing Kit
Post by: Sturmgeschutz on November 22, 2013, 10:06:29 PM
I have used hi-temp auto engine/exhaust  paint and BBQ paint