2aHawaii
Tools and Uses => Reloading => Topic started by: BLKDRGN on July 11, 2014, 09:05:18 AM
-
I have my brass and bullets in sealed plastic containers. If I clean my brass how long will it last before it tarnishes? Will desiccant help in slowing down the process?
-
Should last a long time with low moisture. Ammo stored in air tight ammo cans come out shiny even after 50 years.
-
Oh awesome. I thought it was like a month or so. Thanks.
-
I throw a desiccant pack in the ammo can for good measure. I figure if the gasket starts to leak then the desiccant will indicate (get the orange indicator ones). I grab mine on Amazon but I'm sure they're sold everywhere, throw them in the microwave on defrost for a minute or so and you can reuse them.
-
Thanks. I'll put some in just in case. There are brass with clear coats that last a long time but this is raw. I haven't reloaded yet but I think today all my equipment will come in. I don't want to tumble all my brass and let it sit until I'm ready to reload which may be several months and then it's all tarnished and then have to re-tumble it again. My reloading equipment is not at my house so I only have limited time to work on stuff. If I can tumble all the brass and let it sit until I'm ready it would save me a lot of time.
-
I'll double check what Mark does.
-
I found some prepped/primed brass that I stored in Tupperware containers for over 15 years. Didn't have any desiccant in them. The shine wasn't as good as when I tumbled them, but they looked pretty good. Loaded them up and all shot fine.
-
Rice works good too....put it in little cloth bags 1 cup will cover from 1 cubic to 8 cubic feet
Use Hinode