2aHawaii

Tools and Uses => Firearms and Accessories => Reviews => Topic started by: Bota-CS1 on March 16, 2015, 10:38:00 AM

Title: Nordic Components - +6 MXT extension and barrel clamp
Post by: Bota-CS1 on March 16, 2015, 10:38:00 AM
Nordic Components
https://nordiccomp.com/ (https://nordiccomp.com/)


+6 MST Extension

After the last HDF shotgun class I wanted to increase the capacity of my Remington 1100.  I read a lot of product reviews online and decided upon the Nordic Components MXT +6 extension.  I chose this extension so my shotgun would have the same capacity as my rifle and pistol.  Installing the tube was the easiest since you just have to screw it on in place of your old tube, with the spring being the only part you actually have to do any work on.  I say that the spring they send you is almost double the length of what you need to get the follower to work.  I just laid my shotgun down on the workbench and cut the excess off with a Dremel and a grinding bit.  I reassembled and function checked it and found the spring was still a little too long so I trimmed it down a few coils more.  After adjusting the spring for the second time, I ran it through it's paces.  It functioned flawlessly.  In between both adjustments I wiped down the spring with a shop towel to remove any small particles that might cause the spring or follower to get hung up.  One last wipe down and a very light coat of FireClean on the spring and it was done.  Total time 10 min - probably half that if I didn't have to trim the spring a 2nd time.

The finish on the extension was good and what you would expect from a reputable company.  There weren't any burrs or machine marks on the tube or nut.  I found the texture of the Nordic Component nut to be at a better angle and easier to unscrew than the stock magazine nut.


Railed Barrel Clamp

It came in a small sealed plastic bag to prevent rust which was nice.  The anodizing was good and even and thought it's more expensive than other railed barrel clamps, it's the one that fits best with their +6 extension.  The only draw back is that you have to use two different size allen wrenches to install the clamp and the rail.  The clamp takes one size, but the rail takes a smaller size. That's the only drawback to the clamp that I can find.

Pics to follow




Title: Re: Nordic Components - +6 MXT extension and barrel clamp
Post by: mf_tom on April 26, 2015, 10:25:55 PM
Good Review...