2aHawaii
General Topics => General Discussion => Topic started by: buckjay on February 13, 2012, 04:11:42 PM
-
I have a few USGI mags I was hoping to get cerakoted black or some other variation. Anyone on Oahu have the stuff?
-
I have a few USGI mags I was hoping to get cerakoted black or some other variation. Anyone on Oahu have the stuff?
How thick is the cerakote finish? I've got two Beretta magazines that were left on a piece of damp felt (derp!) and the finish is gone where they were resting on the material. I keep 'em rust-free with CLP, but the bare metal tests my anti-corrosion resolve dang near daily. Would cerakote be too thick?
-
How thick is the cerakote finish? I've got two Beretta magazines that were left on a piece of damp felt (derp!) and the finish is gone where they were resting on the material. I keep 'em rust-free with CLP, but the bare metal tests my anti-corrosion resolve dang near daily. Would cerakote be too thick?
clear coat em.
-
clear coat em.
What would you recommend for clear coat?
-
clear coat em.
:shake: :shake: :shake:
My sarcasm meter is tingling.
:shake: :shake: :shake:
-
"Bananaclip" on this forum, knows how and has the stuff to refinish metal. :thumbsup:
-
:shake: :shake: :shake:
My sarcasm meter is tingling.
:shake: :shake: :shake:
buahahaha
-
I couldn't think of a clear coat product I've seen that seems like it would work...figured it wouldn't hurt to ask for clarification. Maybe I've been duped. :wacko:
-
:shake: :shake: :shake:
My sarcasm meter is tingling.
:shake: :shake: :shake:
I'm dying to know...........
-
My gunsmith has a few colors. What color did you need? or which finish type?
-
My gunsmith has a few colors. What color did you need? or which finish type?
I would like my whole AR FDE. how much does he charge?
-
I would like my whole AR FDE. how much does he charge?
I echo this, but with a 1911.
-
E-tac does a type of coating. I don't know if it's cerakote but it looks pretty durable. I believe they are located in waipahu. He also does gunsmithing.
-
Hmmmm (Scratching Chin)
-
Take the mag apart, clean the parts you are going to paint with dishwashing soap (preferably Dawn).
Then light sand with sand paper to give the paint something to grab on to...
Clean again with (Dawn) and acetone... Stay safe and use gloves and work with good ventilation...
Then stuff papertowel or toilet paper inside the mag where you don't want paint to go...
Then tape off all the other parts you don't want painted...
Spray light even coats... Wait about 10min between coats.. A heat gun between coats works good...
Depends what color you want, I buy Duplicolor heat resistant ceramic engine paint...
I hope this will help a little.. It's just suggestions..
Have fun.. Before you know it, you'll be painting everything!!
-
Any new information?
-
heat resistant ceramic engine paint...
Bake them in oven as per instructions. Its hard and durable, but use thin coats.
-
Wow... Original post is almost 2 years old ;D Check Moore's Tactical Coatings in the Vendors forums, they do Ceracoat.
-
Wow... Original post is almost 2 years old ;D Check Moore's Tactical Coatings in the Vendors forums, they do Ceracoat.
MAHALO !