2aHawaii
Tools and Uses => Reloading => Topic started by: Rhed on December 27, 2020, 08:57:09 AM
-
Picked up this primer seater kit to incorporate it with my RCBS bench primer seater. It’s not a CPS, but the machining and built on this is pretty impressive. And since I already have the RCBS bps, I figured why not. It also comes with this nice gauge to check seating depths. Checked some of recent reloads I did, and to my surprise it was seated too deep and depth measured all over the place. Been seating primers by feel all this time. In Holland’s video, any where from 3-5 thousandths below is ideal. I’ve read also that primer seating depths also has something to do with sd. Well, I don’t believe it till I see it. Will do some experiment with that on my next reload.
(https://imagizer.imageshack.com/v2/xq90/924/4cY9Hr.jpg) (https://imageshack.com/i/po4cY9Hrj)
(https://imagizer.imageshack.com/v2/xq90/924/ZzsHsB.jpg) (https://imageshack.com/i/poZzsHsBj)
(https://imagizer.imageshack.com/v2/xq90/922/Wv56tS.jpg) (https://imageshack.com/i/pmWv56tSj)
(https://imagizer.imageshack.com/v2/xq90/924/VtPInC.jpg) (https://imageshack.com/i/poVtPInCj)
(https://imagizer.imageshack.com/v2/xq90/922/Wr3EwD.jpg) (https://imageshack.com/i/pmWr3EwDj)