2aHawaii

Tools and Uses => Reloading => Topic started by: wirecounter on August 26, 2012, 09:00:10 AM

Title: Micrometer Powder Bar Kit for Dillon
Post by: wirecounter on August 26, 2012, 09:00:10 AM
Worked up loads for my .223 this weekend and made use of the subject micrometer from UniqueTek for my Dillon 550.  This is a must have if you own a Dillon.  I created the calibrated "curve" (in quotes as it is not a curve but a linear relation)) for TAC powder with a few measured samples.

I worked up 8 different loads following the OCW method, thanks Heavies  :shaka:.  And I weighed a few samples and they were spot on.  No more guessing with the stupid (stupid because it provides no useful info) bolt that comes with the machine.  Must have saved over an hour of turning the stupid bolt, throw three loads for the machine to "catch up," measuring several loads and weighing to get their average, then load, and repeat the process.  Probably saved more like two hours.

And, unless you have a dedicated bar for each of the calibers you load then this micrometer saves time when you switch between calibers and powders, once you have the "curve" for each powder.  This is a no brainer!

Disclaimer: I do not work for UniqueTek nor do I receive any incentives for this post . . . LOL.
Title: Re: Micrometer Powder Bar Kit for Dillon
Post by: Inspector on August 26, 2012, 02:28:42 PM
Thanks for sharing this info with us. I want to someday go with Dillon for a progressive setup. And this is good for me to know.

I currently use an RCBS Powder Measure with the micrometer adjustment. It will consistently throw a charge of Titegroup within 0.1gr every time. Good enough for pistol loads. I still weigh every charge when loading rifle.