2aHawaii
Tools and Uses => Reloading => Topic started by: Heavies on September 10, 2012, 03:41:42 AM
-
I recently ran out of my usual lube and did not have time to head over to the gun shop to pick up more. So, on the net, I saw that some folks were using Kiwi Mink Oil shoe polish to lube their cases.
(http://di1-1.shoppingshadow.com/images/pi/70/48/39/46122825-260x260-0-0_Kiwi+2+5+8oz+Mink+Oil.jpg)
I cleaned up my dies and touched my finger to the polish. I ran my finger around the base of the case with a VERY light coat of wax applied to the case. First shell there was a little resistance while the freshly cleaned die was coated with the polish, but a lot less force applied than with the other lube I had been using. Thereafter, the cases slid into the sizer SUPER SLICK. To remove the lube I used my normal method of NeverDull and rag wipe during my trim/chamfer operation. A very light coat goes a long long way with this stuff, and shoulder bumps were super consistent. No more excess lube messing up the bump. :D
Has anyone here used this to size cases, and are there any cons to using this product for this application?
Thank you for your thoughts.
-
will try that!
I've been using LEE lube in 90% alcohol because it is the cheapest and works well.
http://www.kiwicampdry.com/mink-oil.aspx (http://www.kiwicampdry.com/mink-oil.aspx)
says it contains mink oil. silicone, lanolin
sounds like case lube to me!
-
Try pam(cooking spray).
-
+1 on pam cooking spray. Then I rinse cases off with brake cleaner and vibe clean for a hr.
Dave