2aHawaii

Tools and Uses => Firearms and Accessories => Topic started by: West740 on April 28, 2024, 09:58:47 PM

Title: Chipping at cam pin hole
Post by: West740 on April 28, 2024, 09:58:47 PM
Just went to sight in a new build today. Put roughly 50-60 rounds through the gun and took apart to give a quick wipe down at home. Noticed a chip on the bolt at the cam pin hole. Bcg is a Noveske. Anyone ever had this issue with such a low round count?
Title: Re: Chipping at cam pin hole
Post by: Flapp_Jackson on April 28, 2024, 10:03:35 PM
Did you lube the bolt well?  That's the most important part to make sure is properly lubricated.

You can under-lube it, but too much oil won't hurt it.  You'll just risk getting oil thrown back in your face.
Title: Re: Chipping at cam pin hole
Post by: West740 on April 28, 2024, 10:11:40 PM
Yea I used fcd snake oil gun lube on it prior to the range. Just cleaned it off for the pic.