2aHawaii

Tools and Uses => Firearms and Accessories => Topic started by: aieahound on January 14, 2013, 10:47:22 AM

Title: Chamber check ?
Post by: aieahound on January 14, 2013, 10:47:22 AM
Is there anyway to check a chamber to tell if it's .223, .223 Wylde or 5.56 ?

I bought a used upper assembly with a 20" barrel and the prior owner wasn't sure if it was .223 or .223 wylde.

Much Mahalo for any insight.   :shaka:
Title: Re: Chamber check ?
Post by: Cougar8045 on January 14, 2013, 10:55:44 AM
Whatever the barrel is stamped should be what it is.  If it's not marked, I don't know what to tell you.  Headspace gauges, maybe?
Title: Re: Chamber check ?
Post by: SpeedTek on January 14, 2013, 11:00:44 AM
It has to be stamped on the barrel. or etched

they are very hard to tell even with a headspace gauge.  I have to drop a reamer in to really know.
especially if the barrel has a lot of rounds threw it,
Title: Re: Chamber check ?
Post by: Bunker on January 14, 2013, 11:25:07 AM
It has to be stamped on the barrel. or etched

they are very hard to tell even with a headspace gauge.  I have to drop a reamer in to really know.
especially if the barrel has a lot of rounds threw it,

This reamer chart may come in handy from AR15barrels.
(http://i1287.photobucket.com/albums/a632/Bunker9939/223-556_zps126c4d2c.jpg)
Title: Re: Chamber check ?
Post by: aieahound on January 14, 2013, 11:57:31 AM
Thanks for the replys.

It's got a free float handguard that I can't get completely off without removing the gasblock. But I can't find the caliber markings anywhere on it.

Could they be under the gasblock ?  Should I be concerned with the lack of markings.

Also, it's a HBAR stainless barrel. What's the worst that could happen if I shot 5.56 through it if it's a .223 chamber ? Blown primers? Blown Upper ? Blown Head ?  :o
Title: Re: Chamber check ?
Post by: SpeedTek on January 14, 2013, 04:15:36 PM
All modern ar15 barrel are all chambered in 556. Only a few from the 60's were 223.

So I would not worry.  The support area around the barrel is 1" diameter.  So there is
A lot steel there.