1. 2aHawaii
  2. Tools and Uses
  3. Reloading
  4. Problems with the Hornday bullet feeder die
Print
Pages: [1]

Problems with the Hornday bullet feeder die (Read 2230 times)

shibby95

Problems with the Hornday bullet feeder die
« on: September 02, 2013, 10:56:33 PM »
Recently bought a Hornady bullet feeder die for 9mm, followed all the instructions listed on the Hornady website, brass case flared to the appropriate .385 and all the collets place in order, collet A first and then collet B. When the brass case goes into the die, I heard a slight pop sound as the brass is being removed from the "A" collet, but there's not bullet  >:(. I gone over and over removing the collets, wiping down the interior of the die, so now I'm lost....any suggestions  ???
Logged

Bcspy

Re: Problems with the Hornday bullet feeder die
« Reply #1 on: September 08, 2013, 12:13:49 AM »
Pic might help.
Logged
Print
Pages: [1]
« previous next »