Reloading 338 Lapua (Read 2903 times)

Bcspy

Reloading 338 Lapua
« on: October 31, 2013, 12:53:31 PM »
Just recently purchased a Lyman 338 Lapua dies set.  I use Dillon lube and work great for 308 and 223.  Never again for 338 Lapua Brass.  The brass got stuck, unable to take it out, and now the size die is trashed.  Any better lube and I need to buy new dies and mix review with Foster and Redding.  Not sure what to buy.  I see comp and S type for Redding.  Price is high so I don't want to make any mistake on purchasing.  I should have buy and cry once.   

powder monkey

Re: Reloading 338 Lapua
« Reply #1 on: October 31, 2013, 02:08:06 PM »
imperial sizing wax and co ax press........ :thumbsup:
« Last Edit: October 31, 2013, 03:53:40 PM by powder monkey »

Bcspy

Re: Reloading 338 Lapua
« Reply #2 on: December 06, 2013, 05:03:52 PM »
Anyone got the Sierra reloading data book?  Just want to double check my load.  I'm about to load 338 Lapua Sierra MK 250 HPBT, Hornady brass, 85 gr of H4831, trim 2.714, and oal 3.550.  Need to double check the grain min and max load.  Thanks

ren

Re: Reloading 338 Lapua
« Reply #3 on: December 06, 2013, 05:08:22 PM »
Did you try placing the stuck case and die in the freezer; then try to remove it?
Deeds Not Words

Bcspy

Re: Reloading 338 Lapua
« Reply #4 on: December 06, 2013, 05:35:28 PM »
No the die decap pin is trashed.  Body still good.  I pick up the redding die set and .364 and .365 bushing.   Using .365 and also the wax is awesome.  Thanks for the tip. Never got any stuck after use.