Brass AR pistol (Read 2143 times)

suka

Brass AR pistol
« on: April 20, 2014, 05:46:53 PM »
Getting bored,
Had an idea of milling a complete AR out of brass. Besides the barrel, grip and BCG. Everything will bling under the sun ; like a gold gun.
Brass upper
Brass lower
Brass hand guards
Brass muzzle device

Since brass bar stock is expensive , I'll eliminate many features of the normal AR.
Semi operation
Brass deflector
Buffer tube
Fwrd assit
Pictny rails
Fancy cosmetic exterior

Falken Hawke

Re: Brass AR pistol
« Reply #1 on: April 20, 2014, 08:12:56 PM »
Considering the weight of brass (Specific Gravity 8.4-8.7) versus iron or steel (SG 7.03-7.13 & 7.7-7.83 respectively) and aluminum (SG 2.55-2.8 ), one might consider brass plating polished steel or color anodizing aluminum.

Another consideration may be the hardness of the materials.  Brass is harder than raw aluminum but after the typical anodizing process, the aluminum is harder.  Steel can also be case hardened so the main variable would be the thickness of the plating on the steel as far as durability goes.

I can't be certain at this time but I would try to research "Galvanic Corrosion".  Basically, there are metal combinations that should be avoided because they corrode when in contact with each other.

I would have other concerns but people who've put together AR platforms should be able to address them appropriately.

All that said, sounds like it would look interesting.  Kinda reminding me of steampunk though, I don't know if that's good or bad...

suka

Re: Brass AR pistol
« Reply #2 on: April 20, 2014, 08:54:10 PM »
Your right , brass is pretty heavy. Just at the local supplier compared to aluminum the brass weighs a ton.

Cost of materials alone ran about $120
Upper, lower, foregrip.