With three phase power, imagine two more lines on that graph, each with peaks and valleys offset by one third of the distance.
Your description most accurately describes the current wave that flows in the ground wire of a 3-phase system. Further, if you think about, assuming all your 3 sine waves are of equal amplitude (voltage) the sum of all 3 with offset phases should equal zero current. And indeed, it is not uncommon for 3-phase systems to completely omit the ground (return current) wire, as it is not needed to complete a circuit, in part due to this reason (the "ground" wire is always supposed to carry zero current in theory). Note that engineers call this a ground wire, but a physicist might not, as it is not a wire that connects a circuit to the earth (which is what physicists as well as engineers call a grounding wire).
Part of the reason 3-phase design is most commonly used in energy transmission is that you can just dump the ground (return wire) and thus eliminate one-quarter to one-half (depending on how you look at it) of all the wire you are using in the world, saving on wire cost.
From the point of view of ordinary household power outlets and electronic devices you use, 3-phase power is invisible because by the time it gets to you, it's just an ordinary single-phase circuit. Only 1 of the 3 wires/waves/phases physically goes to your house or outlet, and each phase is like a single-phase circuit.
There is yet another terminology clash with physicists and engineers over what a single-phase circuit means. For this post I am using the physics/high school definition of single-phase circuit: a basic loop circuit. The picture that suka posted at the top of this page is what physicists might call a split-phase circuit. However, engineers got lazy and started calling that a single-phase circuit, too. A better name for split-phase circuit would be to call it a 2-phase circuit, not single-phase circuit. (But instead, engineers call something else a 2-phase circuit, something that is never used in practice).
I probably should understand 3-phase power better than most people (my job description has been mentioned in this thread) but I don't really care about it. I have a master's degree in theoretical physics yet never learned about it in school. I believe it's something that only electrical engineers concern themselves with.