Bent Decapping Pin (Read 1743 times)

Inspector

Bent Decapping Pin
« on: July 06, 2020, 07:43:17 AM »
I have been using my Lee Universal Decapping Die for almost 20 years, I think. And I finally bent the pin in it for the first time. I have decamped some of the hardest crimped primers to get out with old 30’06 ammo. No problems. But then I got a good deal on some unprocessed 223 range brass. It was so dirty I didn’t want to put it through my dies until I washed them. So I broke them up into 100 piece batches and started to decap them every time I had a few minutes. The first 200 pieces went fine on the 3rd batch I bent the pin on a piece of 223 brass with the headstamp: F&S 223 REM with red primer sealant. I did some looking down the brass and it appears the flash hole is undersized. I thought it was my imagination. So I dug through my batches and found another piece and I see the same thing. The flash hole is undersized. After doing a little Google Foo I found that I am not the only one who had this problem.

Be on the lookout for this headstamp if you are picking up range brass. It is easy to spot with the red primer sealant.
SCIENCE THAT CAN’T BE QUESTIONED IS PROPAGANDA!!!

Lihikai

Re: Bent Decapping Pin
« Reply #1 on: July 06, 2020, 09:19:14 AM »
I bent my Lee decapper last year - I think it was a Berdan case.  I've been trying this hardened decapping pin for a year and so far it's been working out great:

https://www.ebay.com/itm/HARDENED-STEEL-Decapping-Pin-Upgrade-for-Lee-90783-90292-universal-decap-die/221946800846?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649

Inspector

Re: Bent Decapping Pin
« Reply #2 on: July 06, 2020, 10:04:20 AM »
I bent my Lee decapper last year - I think it was a Berdan case.  I've been trying this hardened decapping pin for a year and so far it's been working out great:

https://www.ebay.com/itm/HARDENED-STEEL-Decapping-Pin-Upgrade-for-Lee-90783-90292-universal-decap-die/221946800846?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649
I hate you I hate you I hate you!!!  :rofl:

I just bought a new pin and a back up just in case. And now I have to buy this hardened one!!! It’s all your fault!!!  :rofl:  My credit card has been getting a workout these last few months!
SCIENCE THAT CAN’T BE QUESTIONED IS PROPAGANDA!!!

Lihikai

Re: Bent Decapping Pin
« Reply #3 on: July 06, 2020, 03:33:21 PM »
Well at least you'll never have to buy more pins after this.

The Lee factory pin is very good and robust.  Over the years I've decapped many thousands of crimped cases without problem.  I keep the collet nut holding the pin pretty tight since some foreign military brass is crimped pretty good.  There's been a few times that the primer just won't come out and the hardened pin punches thru the primer.  I stick an awl into the hole punched by the pin and pry the primer out.