Glock Barrels (Read 12444 times)

keoni008

Glock Barrels
« on: September 04, 2012, 11:24:35 PM »
Is it true your not suppose to shoot reloads threw the stock barrel of a glock?

Inspector

Re: Glock Barrels
« Reply #1 on: September 04, 2012, 11:50:36 PM »
Is it true your not suppose to shoot reloads threw the stock barrel of a glock?
Never heard that one. But I know you are not supposed to shoot lead thru the stock barrel due to the type of rifling.
SCIENCE THAT CAN’T BE QUESTIONED IS PROPAGANDA!!!

hnl.flyboy

Re: Glock Barrels
« Reply #2 on: September 04, 2012, 11:52:26 PM »
Never heard that one. But I know you are not supposed to shoot lead thru the stock barrel due to the type of rifling.

+1 Reloads are fine if they're jacketed bullets.  I have a friend that shoots lead out of stock barrels anyway, but keeps his round counts low before cleaning the barrel thoroughly.  YMMV at your own risk.
LEX MALLA, LEX NULLA

FPC, SAF Life, HDF Life, GOA, HRA, Fun Factory VIP

swissk31

  • Trade Count: (+28)
  • Sr. Member
  • ****
  • Posts: 377
  • Total likes: 21
  • Liberalism is a mental disorder - M. Savage
  • Referrals: 1
    • View Profile
Glock Barrels
« Reply #3 on: September 05, 2012, 04:25:53 AM »
I believe there was some concern with shooting 40 s&w reloads. The glock barrel does not fully support the case.

keoni008

Re: Glock Barrels
« Reply #4 on: September 05, 2012, 04:50:08 AM »
+1 Reloads are fine if they're jacketed bullets.  I have a friend that shoots lead out of stock barrels anyway, but keeps his round counts low before cleaning the barrel thoroughly.  YMMV at your own risk.
So shooting lead is ok if you clean the barrel really good?

hnl.flyboy

Re: Glock Barrels
« Reply #5 on: September 05, 2012, 07:48:03 AM »
So shooting lead is ok if you clean the barrel really good?

I'm not suggesting you do it.  I just know of someone who does, and still has both his hands.

I don't reload 9mm yet (need to buy a ton of stuff for my progressive), but I already have an aftermarket barrel for my Glock for when I do shoot reloads.
LEX MALLA, LEX NULLA

FPC, SAF Life, HDF Life, GOA, HRA, Fun Factory VIP

Jl808

Glock Barrels
« Reply #6 on: September 05, 2012, 10:27:09 AM »
Is it true your not suppose to shoot reloads threw the stock barrel of a glock?

I heard the same. My friend and I spoke with someone at the range with an aftermarket Glock barrel BECAUSE he only shot reloads.
I think, therefore I am armed.
NRA Life Patron member, HRA Life member, HiFiCo Life Member, HDF member

The United States Constitution © 1791. All Rights Reserved.

flaboy808

Re: Glock Barrels
« Reply #7 on: September 05, 2012, 10:43:31 AM »
I heard the same. My friend and I spoke with someone at the range with an aftermarket Glock barrel BECAUSE he only shot reloads.

Oh crap... I've been shooting reloads on my 23.  Time to go look for an after market barrel I guess.
The Supreme Court has ruled that you, as an individual, have no right to protection by the police. Their only obligation is to protect "society".

hnl.flyboy

Re: Glock Barrels
« Reply #8 on: September 05, 2012, 12:11:12 PM »
Oh crap... I've been shooting reloads on my 23.  Time to go look for an after market barrel I guess.

Was it with lead bullets?

If so, what are your thoughts?  Do the grooves look like they're collecting lead?

Should let keoni008 know!
LEX MALLA, LEX NULLA

FPC, SAF Life, HDF Life, GOA, HRA, Fun Factory VIP

Jl808

I think, therefore I am armed.
NRA Life Patron member, HRA Life member, HiFiCo Life Member, HDF member

The United States Constitution © 1791. All Rights Reserved.

Inspector

Re: Glock Barrels
« Reply #10 on: September 05, 2012, 04:02:34 PM »
All this is interesting. However, after reading all the provided information and doing my own research it appears that most of the KaBooms were do to leading problems, overloaded handloads, early issues with the .40 S&W cartridge.

1. Overloaded handloads can make any pistol got KaBoom.
2. Leading issues can occur in any pistol but due to the type of rifling that Glock uses it exacerbates the problem and apparently can occur within a few hundred rounds.
3. The .40 S&W cartridge had problems during its infancy and the Glock barrel design exacerbates this issue.

So if I don't overload my handloads, and I don't use lead bullets, and I use brass in good condition I would think shooting handloads is okay. Especially if you are shooting 9mm or one of the other calibers.

It is funny that this just came up as while I have been reloading 9mm for over 30 years I have never ran my reloads through my Glock. That is until now. I just reloaded my first 300 rounds for use through my Glock 17. I have no issues with shooting these reloads through my Glock. And I will let you know how it goes after my foot heals. I loaded 100 rounds of 147gr Hornady XTP using Titegroup at 3.4 grs (Mid point in my book). 100 rounds of 125gr Hornady XTP  and 100 rounds of 124gr Sierra FMJ using Titegroup at 4.2grs (About Mid Point in my book). I am using once fired (through the Glock17) high quality brass with CCI 500 small pistol primers and a taper crimp.
SCIENCE THAT CAN’T BE QUESTIONED IS PROPAGANDA!!!

flaboy808

Re: Glock Barrels
« Reply #11 on: September 05, 2012, 08:05:35 PM »
Was it with lead bullets?

If so, what are your thoughts?  Do the grooves look like they're collecting lead?

Should let keoni008 know!

I've been using jacketed so it should be ok I guess. 

Nothing that I can see in the grooves from the jacketed reloads.  I like them just fine though.  I almost ordered the lead but good thing I didn't.
The Supreme Court has ruled that you, as an individual, have no right to protection by the police. Their only obligation is to protect "society".

keoni008

Re: Glock Barrels
« Reply #12 on: September 05, 2012, 10:16:24 PM »
Ok, so i guess bottom line do not shoot LEAD threw the stock glock barrels! What about copper plated bullets are they ok to shoot threw the stock glock barrels?

[attachment deleted by admin]

Kingkeoni

Re: Glock Barrels
« Reply #13 on: September 05, 2012, 11:12:40 PM »
Lead is a definite NO.

Glock advises against using reloaded ammo in their firearms, but so do many manufacturers.

The biggest reason for that is the lack of quality control from reloader to reloader.

For every guy that spends hours getting the measurements perfect then double and triple checks them, there's some idiot that tries to create super hot loads and doesn't measure anything.

I have friends who shoot reloaded ammo exclusively in their factory glock barrels with no problems whatsoever.

They all use jacketed ammo, though.
Your number one Option for Personal Security is a lifelong commitment to avoidance, deterrence, and de-escalation.

Someday someone may kill you with your own gun, but they should have to beat you to death with it because it is empty.

keoni008

Re: Glock Barrels
« Reply #14 on: September 06, 2012, 02:16:49 AM »
Lead is a definite NO.

Glock advises against using reloaded ammo in their firearms, but so do many manufacturers.

The biggest reason for that is the lack of quality control from reloader to reloader.

For every guy that spends hours getting the measurements perfect then double and triple checks them, there's some idiot that tries to create super hot loads and doesn't measure anything.

I have friends who shoot reloaded ammo exclusively in their factory glock barrels with no problems whatsoever.

They all use jacketed ammo, though.
Is there a difference between jacketed  and copper plated heads?

Heavies

Re: Glock Barrels
« Reply #15 on: September 06, 2012, 04:04:50 AM »
Copper plated is softer than jacketed, and slightly more tough than regular lead.

zippz

Re: Glock Barrels
« Reply #16 on: September 06, 2012, 01:07:22 PM »
I've shot around 5k or so plated reloads for my 40SWglock, no problems.  Main thing is to check your cases for damage each time you reload, and keep the pressures moderate.  Plated is more expensive than lead, but cheaper than jacketed.  It's just a really thin coating of copper while jacketed has a very thick coat of copper.

keoni008

Re: Glock Barrels
« Reply #17 on: September 06, 2012, 10:42:10 PM »
I've shot around 5k or so plated reloads for my 40SWglock, no problems.  Main thing is to check your cases for damage each time you reload, and keep the pressures moderate.  Plated is more expensive than lead, but cheaper than jacketed.  It's just a really thin coating of copper while jacketed has a very thick coat of copper.
Is your glock the factory barrel?

zippz

Re: Glock Barrels
« Reply #18 on: September 09, 2012, 09:37:32 PM »
yup

13ROKEN

Re: Glock Barrels
« Reply #19 on: September 11, 2012, 01:54:59 AM »
Same here, been shooting 9mm reloads on my g34 gen4, with rainier copper plated bullets and have  no problems