Reloading with VLD Bullets (Read 7612 times)

Inspector

Reloading with VLD Bullets
« on: October 08, 2012, 06:03:22 PM »
Recently I was at YG and found they finally received a shipment of Berger Bullets which I have not seen from them in many months. They just happen to have a box of .223 70gr VLD Bullets. I have not loaded any VLD (Very Low Drag) Bullets from Berger yet. So I bought a box (Damn expensive) and looked for the loading info from Berger. As usual Berger still has not put their loading info on the Internet nor have they produced a book. So I e-mailed them with my request as they state on their website. In the meantime I came up with 5 loads using my trusty Sierra loading manual using the 69gr Matchking as my guide. I started at the lowest recommended as my standard practice and worked my way up to about 10%-20% below the recommended max. This is my standard practice for working up a new load. I try to stay well below the max until I fire a few below max to see what the primers and cases look like. If I find my groups are best at the highest load I will work up slowly to find the best group. But most of the time my rifle groups best well below the maximum loads I have tried.

I started setting the bullets in the cases of the second from the highest load and I noticed CRUNCHING feeling/noises. Obviously I was compressing the powder. So I checked the weight of the powder and it was correct. Next I checked the OAL of 2.26" which was correct. Looked carefully and it appears that I am compressing the powder with this load. I stopped to think things over and found that Berger had replied to me VERY quickly on Saturday afternoon. I have to give them props. So I checked out their recommended loads and their maximum recommended was about 10% over my mid load from the Sierra Book. Ooooooops! Wow! Am I glad I stopped and realized what I was doing. VLD bullets are a lot longer than a standard bullet. So much so that I had to back off on the amount of Varget I was using. I re-worked my loads using my mid load as the maximum. And I came up with two loads that printed below half inch at 100yds. All 5 loads were less than MOA. I love Berger Bullets!

Most of you probably already know all of this. Just thought I would share my experience since I am new to reloading rifle rounds. Reloading pistol rounds is so much easier!!!!
SCIENCE THAT CAN’T BE QUESTIONED IS PROPAGANDA!!!

ren

Re: Reloading with VLD Bullets
« Reply #1 on: October 08, 2012, 06:13:15 PM »
I crunch 77 SMKs and Noslers with my service rifle load regularly. That's 24.0 grains of RL15 in a LC case, loaded to mag length. I get around 2700 fps and get good accuracy. I can get a clean at 200 and 300 yards with that same load. From what I read and experiences with other competitors is that VLDs are very sensitive to jump because of their thin jackets. Bergers are awesome bullets - with the price tag to boot. I read that the 73 Bergers are the best short line load, althought they are not VLDs and would have been selected as the bullet for Mk262 ammo if they got production down.
« Last Edit: October 08, 2012, 06:20:30 PM by ren »
Deeds Not Words

Heavies

Re: Reloading with VLD Bullets
« Reply #2 on: October 08, 2012, 06:20:48 PM »
Sweet. I really like Berger bullets too. I used to use the 6mm 105 VLDs in my 6mmBR.  They were a joy to shoot and a lazer at 600 yards.  Wind bucking was very good and helped me alot with my poor wind doping skills.  Heeh. 

The new hybrid bullets, I've been using in my .308,  are the easiest bullet I have ever worked a load for. The price of these projectiles are really expensive though, so I usually reserve them for our F-Class matches.   

Inspector

Re: Reloading with VLD Bullets
« Reply #3 on: October 08, 2012, 06:48:05 PM »
I crunch 77 SMKs and Noslers with my service rifle load regularly. That's 24.0 grains of RL15 in a LC case, loaded to mag length. I get around 2700 fps and get good accuracy. I can get a clean at 200 and 300 yards with that same load. From what I read and experiences with other competitors is that VLDs are very sensitive to jump because of their thin jackets. Bergers are awesome bullets - with the price tag to boot. I read that the 73 Bergers are the best short line load, althought they are not VLDs and would have been selected as the bullet for Mk262 ammo if they got production down.
They don't reference RL 15 in their load data. But just for your reference Berger stated that a maximum of 23.5 grains of Varget brings 2879fps and 107.6% fill ratio. Which means at this load I will be crunching powder. However, I figured I could use 24.5grs and 25.5grs of Varget as stated by the Sierra Book for the 69gr Matchking (Not a VLD). So as you can see I was WAY over Berger's recommendation for powder. And loading with the Sierra does not crunch the powder that I can tell at 25.5grs. I am glad I listened to my gut on this one.

I am used to compressing powder in 9mm as some powders require it. Just not used to it in .223 yet. As it is I used 23.0grs as a maximum and ended up getting my best group at 22.0grs.

Per your recommendation I will try the 73grs since they are not VLD's. The twist in my barrel is 1 in 9 so I think I can stabilize 73grs (non VLD) as I have tried Hornady V-Max 75grs with good success. Thanks!
SCIENCE THAT CAN’T BE QUESTIONED IS PROPAGANDA!!!

Inspector

Re: Reloading with VLD Bullets
« Reply #4 on: October 08, 2012, 06:55:43 PM »
Sweet. I really like Berger bullets too. I used to use the 6mm 105 VLDs in my 6mmBR.  They were a joy to shoot and a lazer at 600 yards.  Wind bucking was very good and helped me alot with my poor wind doping skills.  Heeh. 

The new hybrid bullets, I've been using in my .308,  are the easiest bullet I have ever worked a load for. The price of these projectiles are really expensive though, so I usually reserve them for our F-Class matches.
I am getting such good results with Bergers I hate to go back to the others I have even just for practice!  :thumbsup:

One day I'll check out the hybrids as I hear some really good things about them. So many bullets and so little time!!!  :rofl:
SCIENCE THAT CAN’T BE QUESTIONED IS PROPAGANDA!!!

ren

Re: Reloading with VLD Bullets
« Reply #5 on: October 08, 2012, 08:09:45 PM »
They don't reference RL 15 in their load data. But just for your reference Berger stated that a maximum of 23.5 grains of Varget brings 2879fps and 107.6% fill ratio. Which means at this load I will be crunching powder. However, I figured I could use 24.5grs and 25.5grs of Varget as stated by the Sierra Book for the 69gr Matchking (Not a VLD). So as you can see I was WAY over Berger's recommendation for powder. And loading with the Sierra does not crunch the powder that I can tell at 25.5grs. I am glad I listened to my gut on this one.

I am used to compressing powder in 9mm as some powders require it. Just not used to it in .223 yet. As it is I used 23.0grs as a maximum and ended up getting my best group at 22.0grs.

Per your recommendation I will try the 73grs since they are not VLD's. The twist in my barrel is 1 in 9 so I think I can stabilize 73grs (non VLD) as I have tried Hornady V-Max 75grs with good success. Thanks!
WOW! 2800 fps ?! Thats close to Mk262 ammo specs. I can't get there with my 77 handloads, but the AMU and current contract ammo for the Guard teams fly around that velocity.
Deeds Not Words

Inspector

Re: Reloading with VLD Bullets
« Reply #6 on: October 08, 2012, 08:20:32 PM »
WOW! 2800 fps ?! Thats close to Mk262 ammo specs. I can't get there with my 77 handloads, but the AMU and current contract ammo for the Guard teams fly around that velocity.
That's what they state in their load data. 2800fps! I really need to get a chronograph. It's about time I break down and get one. I am thinking of the one Heavies reviewed here a few months ago.

BTW, if anyone is interested in the spreadsheet that Berger sent me for the .223 load data I am sure they won't mind if I send it to anyone interested. Just PM with your e-mail address and I'll send it to you.
SCIENCE THAT CAN’T BE QUESTIONED IS PROPAGANDA!!!

justin1098

Re: Reloading with VLD Bullets
« Reply #7 on: October 12, 2012, 06:54:55 PM »
I found that I crunch varget on anything longer than 69 smk's. 77SMK, hornady 68gr mach, and 70gr vld's. I couldn't get the vld's to shoot with the ar-16 magazine length limitations. I think they like to be seated into the lands.