1. 2aHawaii
  2. General Topics
  3. General Discussion
  4. Duracoat Shake 'N Spray Finishing Kit
Print
Pages: [1]

Duracoat Shake 'N Spray Finishing Kit (Read 2142 times)

TastesLikeMetal

Duracoat Shake 'N Spray Finishing Kit
« on: November 22, 2013, 08:58:42 PM »
Anyone sell this locally?  I want to recoat my 10/22's Barrel/Receiver Black.  If not I'll probably Rattle-can it.

Thanks
Ray
« Last Edit: November 22, 2013, 09:05:57 PM by TastesLikeMetal »
Logged

Boomah

Re: Duracoat Shake 'N Spray Finishing Kit
« Reply #1 on: November 22, 2013, 09:39:14 PM »
I haven't run across any locally, Aluma Hyde II is all I've been able to find... Security Equipment is normally where I find it.  It's rattle-can, air dry, and cure.   Comes in a few colors, SE carries flat black (which ends up semi-gloss after a little handling with oily gloves/hands), dark gray, tan, OD, and brown.   I've had a good luck with AH II but it's quite thick, even after it's cured (that takes about a week or two).   So you have to be careful if applying to parts with tight tolerances ;)

HTH, Ahui hou  :shaka:

Boomah

 
Logged

TastesLikeMetal

Re: Duracoat Shake 'N Spray Finishing Kit
« Reply #2 on: November 22, 2013, 09:48:59 PM »
Thanks, I'll probably end up at the Depot tomorrow to pick up some Krylon Black.
Logged

TastesLikeMetal

Re: Duracoat Shake 'N Spray Finishing Kit
« Reply #3 on: November 22, 2013, 09:50:04 PM »
Anyone have input on what Spray Paint is okay for the Barrel?
Logged

Sturmgeschutz

Re: Duracoat Shake 'N Spray Finishing Kit
« Reply #4 on: November 22, 2013, 10:06:29 PM »
I have used hi-temp auto engine/exhaust  paint and BBQ paint
Logged
Print
Pages: [1]
« previous next »