Sig adaptor for 1/2x28 suppressor (Read 3697 times)

suka

Sig adaptor for 1/2x28 suppressor
« on: October 02, 2014, 10:12:00 PM »
Well for Sig they had to be different , although they do make a 1/2x28 threaded barrel. They are extremely hard to get even from Sig themselves.

So what if your suppressor is 1/2x28, not so easy waiting for a new stamp. Well thats a long wait .

Normal sig barrels are threaded 13.5x1 Left.

I found the cheapest chinese tap on ebay for $37. free shipping of course!

Start the lathe and begin machining an adaptor.



1/2x28 suppressor




13.5x1mm Left




On the lathe




Finished adaptor




Too long to CCW    :(
    :(

aieahound

Re: Sig adaptor for 1/2x28 suppressor
« Reply #1 on: October 03, 2014, 09:30:52 AM »
And the purpose of this thread posted in Hawaii ?

Not trying to be a dick, just curious about it's greater good.  :shaka:

dustoff003

Re: Sig adaptor for 1/2x28 suppressor
« Reply #2 on: October 03, 2014, 09:48:17 AM »

And the purpose of this thread posted in Hawaii ?

Not trying to be a dick, just curious about it's greater good.  :shaka:
+1

2aHawaii

  • Administrator
  • Trade Count: (0)
  • Hero Member
  • *****
  • Posts: 3629
  • Total likes: 67
  • Sheepdog
  • Referrals: 17
    • View Profile
    • 2aHawaii
Re: Sig adaptor for 1/2x28 suppressor
« Reply #3 on: October 03, 2014, 10:58:41 AM »
Do you have any more info on what goes into machining something like this?
I am not a lawyer.

"A well regulated Militia, being necessary to the security of a free State, the right of the people to keep and bear Arms, shall not be infringed." - United States Constitution Amendment 2 & Hawaii State Constitution Article 1 Section 17

Buying from Amazon? Click through here

suka

Re: Sig adaptor for 1/2x28 suppressor
« Reply #4 on: October 03, 2014, 11:43:34 AM »
just pissed that sig had the 13.5 threads

and that with a lathe anything can be adapted to fit , say flash hider or extending a barrel to 16".

suka

Re: Sig adaptor for 1/2x28 suppressor
« Reply #5 on: October 03, 2014, 11:48:42 AM »
Do you have any more info on what goes into machining something like this?

just need to get the right tap.
pretty much like using a drill press but horizontal