Pistol Frame (Read 2290 times)

wirecounter

Pistol Frame
« on: July 08, 2017, 08:47:07 PM »
Finally found the piece of paper that Slick wrote down the supplies needed to make a pistol frame with folding legs, see attached.

Just in case you cannot make it out:

2 each of 1" x 3" x 8' plank
2 pieces carriage bolt - 2" long
2 piece wing nuts - 1'4"
2 pieces fender washer - 1/4"
8 each 1-1/4" drywall screw

Assemble as shown.

One change that I made was to use longer carriage bolts (2-1/2" long), used an additional 2 fender washers, got rid of the drywall screws for the bottom cross member, and used the carriage bolt to keep it in place.



oldfart

Re: Pistol Frame
« Reply #1 on: July 08, 2017, 10:53:29 PM »
Your plan is shot full of holes

 :rofl:
What, Me Worry?

rklapp

Re: Pistol Frame
« Reply #2 on: July 09, 2017, 12:18:26 AM »
Literally...
Yahh! Freedom and justice shall always prevail over tyranny, Babysitter Girl!
https://ronsreloading.wordpress.com/

wirecounter

Re: Pistol Frame
« Reply #3 on: July 10, 2017, 04:09:26 PM »
Your plan is shot full of holes

 :rofl:

lol . . . 357 holes that is!