Alternative case lube? (Read 3808 times)

Heavies

Alternative case lube?
« on: September 10, 2012, 03:41:42 AM »
I recently ran out of my usual lube and did not have time to head over to the gun shop to pick up more.  So, on the net, I saw that some folks were using Kiwi Mink Oil shoe polish to lube their cases.



I cleaned up my dies and touched my finger to the polish. I ran my finger around the base of the case with a VERY light coat of wax applied to the case.  First shell there was a little resistance while the freshly cleaned die was coated with the polish, but a lot less force applied than with the other lube I had been using.  Thereafter, the cases slid into the sizer SUPER SLICK.  To remove the lube I used my normal method of NeverDull and rag wipe during my trim/chamfer operation.  A very light coat goes a long long way with this stuff, and shoulder bumps were super consistent.  No more excess lube messing up the bump. :D

Has anyone here used this to size cases, and are there any cons to using this product for this application?

Thank you for your thoughts.

ren

Re: Alternative case lube?
« Reply #1 on: September 10, 2012, 11:20:14 AM »
will try that!
I've been using LEE lube in 90% alcohol because it is the cheapest and works well.
http://www.kiwicampdry.com/mink-oil.aspx
says it contains mink oil. silicone, lanolin
sounds like case lube to me!
Deeds Not Words

ii open

Re: Alternative case lube?
« Reply #2 on: October 17, 2012, 11:39:05 AM »
Try pam(cooking spray).

microage97

Re: Alternative case lube?
« Reply #3 on: October 31, 2012, 02:54:01 AM »
+1 on pam cooking spray. Then I rinse cases off with brake cleaner and vibe clean for a hr.

Dave