If you're just replacing or installing a latch and/or deadbolt on an existing door, then repositioning the striker plate isn't always good enough.
As you saw in his demonstration, the weather stripping cushions the door against the stop moulding. If a burglar pushes hard enough on an outward opening door, or inversely pulls on an inward opening door, he might find the weather stripping "gives" (compresses) enough to let that safety pin fall into the striker plate hole.
The best way to stop this from happening is to make your door stop moulding seated right up against the door when closed. if you have cushy weather stripping, though, that might not be a good fix.
in case of weather stripping, you might be able to drill a few holes beneath or next to the weatherstripping to insert steel pins -- the kind you use for shelf supports. Not the ones with flat ends -- those are probably too short. Use the barrel kind, and make sure they are at least twice as long as the part of the pin you leave showing or longer.
i just installed a steel door on my workshop, and there was weather stripping already included (pre-hung door from HD). So I removed the weather stripping to make it easier to close, and I drilled a hole right behind the striker plate for a 40mm long M5 diameter shelf pin. i placed the hole against the door when it's closed. I also added some tape around the pin for noise reduction and to fine tune the closing position.
Now the door shuts exactly where I want it, and there's no way for anyone to get the latch to travel and cause the safety latch to disengage without destroying the door jamb. If they are willing to do that, then protecting against a door latch attack is not going to stop them.
For my front door, I'm in the process of rebuilding the frame/jamb. No weather stripping, and the stop moulding is not only against the door to prevent the latch problem, but I made my own 2 1/4" wide, 3/8" thick stop moulding. it's that wide because it does double duty: stop for the exterior entrance door as well as stop for the screen door.
Given how easy it might be on some homes to pry the stop moulding off some exterior doors, having a few steel pins embedded in the jamb to act as stops wouldn't be a terrible idea.
Also, one of the biggest mistakes people overlook is the deadbolt they install on a door with a glass window or a door next to a window. If the interior deadbolt mechanism is something you can turn by hand, then anyone can break the glass and reach in to unlock the deadbolt, assuming they can reach from the window to the door.
I use a double cylinder deadbolt. You need a key to lock & unlock it from either side. I leave a key near the door, but away from any windows, both for convenience and emergencies. Don't want to be searching for a key if you really need to get out or keep someone out trying to come inside.
Door security is an entire niche industry. You can get all kinds of upgrades to make the door impossible to kick in, super thick striker plates with extra, longer screws instead of just the 2 short ones the door knob and deadbolt makers include for strike plates, and so on.
https://www.amazon.com/security-strike-plate/s?k=security+strike+plate