Chamber check ? (Read 3046 times)

aieahound

Chamber check ?
« on: January 14, 2013, 10:47:22 AM »
Is there anyway to check a chamber to tell if it's .223, .223 Wylde or 5.56 ?

I bought a used upper assembly with a 20" barrel and the prior owner wasn't sure if it was .223 or .223 wylde.

Much Mahalo for any insight.   :shaka:

Cougar8045

Re: Chamber check ?
« Reply #1 on: January 14, 2013, 10:55:44 AM »
Whatever the barrel is stamped should be what it is.  If it's not marked, I don't know what to tell you.  Headspace gauges, maybe?
I'm just a fluffy white bunny rabbit who lost his way. 

"If a thief be found breaking in, and be smitten that he die, there shall no blood be shed for him. ..."  -Exodus 22:2

SpeedTek

  • Trade Count: (+44)
  • Hero Member
  • *****
  • Posts: 4749
  • Total likes: 126
  • Car Nut, Machinist, Gunsmith & Monkey
  • Referrals: 2
    • View Profile
    • X-Ring on the WWW
Re: Chamber check ?
« Reply #2 on: January 14, 2013, 11:00:44 AM »
It has to be stamped on the barrel. or etched

they are very hard to tell even with a headspace gauge.  I have to drop a reamer in to really know.
especially if the barrel has a lot of rounds threw it,
Political Correctness is FOS
I collect M1 Carbines, PM me if youre selling!
& Bolt Action 308s also 10/22 Rugers.
Buying STOCK Ruger 10/22 parts and bits, PM me.
Now doing Vintage VW Parts!

Bunker

Re: Chamber check ?
« Reply #3 on: January 14, 2013, 11:25:07 AM »
It has to be stamped on the barrel. or etched

they are very hard to tell even with a headspace gauge.  I have to drop a reamer in to really know.
especially if the barrel has a lot of rounds threw it,

This reamer chart may come in handy from AR15barrels.

aieahound

Re: Chamber check ?
« Reply #4 on: January 14, 2013, 11:57:31 AM »
Thanks for the replys.

It's got a free float handguard that I can't get completely off without removing the gasblock. But I can't find the caliber markings anywhere on it.

Could they be under the gasblock ?  Should I be concerned with the lack of markings.

Also, it's a HBAR stainless barrel. What's the worst that could happen if I shot 5.56 through it if it's a .223 chamber ? Blown primers? Blown Upper ? Blown Head ?  :o

SpeedTek

  • Trade Count: (+44)
  • Hero Member
  • *****
  • Posts: 4749
  • Total likes: 126
  • Car Nut, Machinist, Gunsmith & Monkey
  • Referrals: 2
    • View Profile
    • X-Ring on the WWW
Re: Chamber check ?
« Reply #5 on: January 14, 2013, 04:15:36 PM »
All modern ar15 barrel are all chambered in 556. Only a few from the 60's were 223.

So I would not worry.  The support area around the barrel is 1" diameter.  So there is
A lot steel there.
Political Correctness is FOS
I collect M1 Carbines, PM me if youre selling!
& Bolt Action 308s also 10/22 Rugers.
Buying STOCK Ruger 10/22 parts and bits, PM me.
Now doing Vintage VW Parts!