Glock Gen 1 Slide on Gen 3 or 4 Frame? (Read 1872 times)

HUCKLEBUCK

Glock Gen 1 Slide on Gen 3 or 4 Frame?
« on: July 21, 2013, 01:40:04 PM »
I was going to get a gen 3 or 4 frame for my gen 1 21 and 17. I researched the topic and found two known issues: cycling problems on the gen 4 models due to the new dual RSA (which was corrected with a new RSA) and ejector issues, which required some smithing.

So can someone tell me:

1) the spring issues were exclusively spring issues and not related to interactions with frame parts right?  So that shouldn't concern me since I'm using my old frame/spring etc?

2) were the ejector issues on gen 4 AND 3, or just gen 4?

3) were the ejector issues only on 9mm frames or on 21 frames as well?

4) were both issues eventually corrected at the factory so that after a certain manufacture date, gen 4 models no longer had those issues? 

5) if the answer to 4 above is "yes", does anyone know after what manufacture date the issues were corrected?

6) were there any issues with gen 3 frames on gen 1 slides?  Because I don't care about the gen 4 grip changes relative to the gen 3, so if the gen 3's were issue free, I'd go with those.

I emailed glock a month ago and still haven heard from them, so I'm asking all this here.

7) a final question - do I have to register a new frame for a 17 or 21 I already registered?  Or only the slide with the serial number on my old glock gets registered?

Thanks!!

Kingkeoni

Re: Glock Gen 1 Slide on Gen 3 or 4 Frame?
« Reply #1 on: July 21, 2013, 04:06:33 PM »
As far as I know.

Gen 4 is a whole different beast.

You're not supposed to use any other previous generation parts (except magazines if you don't switch mag release side.

Any frame needs to be registered.

In pistols, the frame is the gun.
Your number one Option for Personal Security is a lifelong commitment to avoidance, deterrence, and de-escalation.

Someday someone may kill you with your own gun, but they should have to beat you to death with it because it is empty.

HUCKLEBUCK

Re: Glock Gen 1 Slide on Gen 3 or 4 Frame?
« Reply #2 on: July 21, 2013, 07:47:55 PM »
Got it. Thanks king