Reloading 5.56? Don't limit yourself. There are more recipes for .223. Differences in pressure and chamber dimensions. General rule: you can fire 223 in a 5.56 weapon, but most advise against firing 5.56 in a .223 weapon. Load .223 and don't sweat it.
Do your research first: Check out this book by Christopher Ohland: AR 15 Ammunition Relocating: A beginner's guide....It's available on Amazon. Has specific recommendations and detailed step-by-step guide so that i was able to . load .223 ammo that fired and functioned well in my Savage .223 and ARs on the first try. Recomends Sierra HPBT 69 grn and Varget, which is just one of a zillion possibilities, but as a good a place to start as any.
Books are cheap. Do your research first: The ABCs of Reloading (now in its 9th edition), the .223 Rem edition of the Loadbooks series (cheap [photocopies of various manufacturers' recommended loads). Agree with JC2721, buy a good reloading manual. Sierra, Nosler, Hornady, Lee, etc. Some manufacturers have information on the Internet, but a lot of the other stuff on the web is worth what you pay for it -- nothing. JC's advice about not rushing or cutting corners is well taken. It's easy to make crappy ammo. Just hope the cost of sloppy reloading doesn't get someone hurt.
You can get started for $500 if you shop carefully, but that will likely be just the beginning of a whole new way to spend your money. I started reloading a few years ago, after the first Obama scare, when 5.56/.223 was scarce and expensive. Bought a 550B from Dillon.and a Wilson hand-crank trimmer, Redding balance beam scale. Used the 550B's powder drop. Spent plenty trying to get it to meter more accurately, and learned that there are many powders and powder measures that work better. Now have a couple of $20 Lee PPMs dedicated to particular loads, among several powder measures. Added a couple of Lee presses and an RCBS Rockchucker. Still use the Dillon for seating and crimping. BTW, if you're using once-fired 5.56, add the cost of something to swage out the crimp in the primer pocket. Dillon works for me, but is pricey. Lee stuff is cheap, and might not last, but it's a good way to start on a budget.
Bottom line: If you're going to handload to save money, you will probably be disappointed. Even if you just spend $500 to get started, you'd have to shoot a lot of rounds to cover the difference between commercial ammo and your handloads. Bullets cost money. Figure 10 to 25 cents a round for a decent .224 pill, plus 4 cents and up for a primer, and about 10 cents for powder (roughly based on 23 grains per round, so about 300 loads from a a pound of powder -- 7000 grains ag $30/lb. Those prices are low if you're buying components locally. Didn't even include the cost of brass. You're already looking at about 25 cents/round. Commercial ammo is down to about 37.5 cents per round these days.
HOWEVER, reloading does enable you to tailor ammo exactly for your needs. Once you get the hang of it, you will have the satisfaction of knowing a valuable skill; you will know a heck of a lot more about what happens when you pull the trigger; you will be less dependent on manufacturers and retailers, and when the next scare happens and ammo becomes unobtainable or stupid expensive, you will be happy.