Rklapp
Now you have me wondering
I don't know if this is right. I have to run this by my mentor. (The only thing is he only shoots semi so he always does a full length sizing but I'm loading for bolt gun)
For my fired brass, if the rim passes the min /max for the case gauge but the mouth > max on the gauge, I was planning to trim indexing off the shoulder.
The shoulder of fired brass may not exactly match the shoulder of FL sized brass, but after trimming I was going to check it again in the case gauge. If the mouth is within min/max of the case gauge, it should be ok right?
I would neck size a few times (3?) before doing a FL sizing. Plan is to anneal each time after I do a FL sizing and trimming. After FL sizing/annealing, I would load a cheaper bullet to shoot and produce fired brass. Plan is to use only neck sized fired brass for load development.
I probably have this all mixed up after trying to learn reloading off the web
1. you never want the neck to extend past the mouth of the case gage. The neck could get jammed into the lead of the rifling causing dangerous pressure spikes. Shorter is ok but over the max is a no go.
2. If you only neck size and develop a load, when you FL size (as you must eventually) you may have a point of impact shift or group size change for that load. This is why I FL size the body of the case MINIMALLY each and every time I reload the case. Bumping the shoulder back .002" .003" everytime means consistent ammo everytime.
I use a redding body die first to bump the shoulder of the case back .002" to .003". This die doesn't excessively resize the body of the case. I use a very light coating of Kiwi mink oil as a case lube on the body of the case, I try not to get any on the shoulder portion of the neck. If there is a bunch of lube over there the shoulder, the case can get sized more than desired.
Then I use a Lee mandrel neck sizer die to size and straighten the neck.
Clean off the lube using Oldfarts non clorinated brake cleaner method.
Then trim using the Giruad triway trimmer.
Ammo I make using this method has very minimal to no runout, I never have a hard to chamber round, and every bullet is consistent in impact and accuracy. Fast easy and efficient reloading. Once everything is set up and locked down no need to fuss.